Home Repairs Save Money In The Long Run

Through daily use and constant wear and tear, things in the home wear out and get broken. For this reason a constant attention to maintenance and repairs are required if your home is going to remain in good condition and retain its value. When needed repairs are deferred, they can turn into an unnecessary expense that could have been avoided. Many repairs can be completed by the home owner, but there are some that should only be tackled by a professional.

While it is true that many items on the home can be repaired, there are some that should simply be replaced. Often times, window screens only require the spline to be run back in the groove, but there are other times when a whole new screen must be manufactured to completely cover the opening. The same is true for doors. A good craftsman may be able to repair a broken door, but before agreeing to this, make sure that you will not be losing any security when this is completed. Otherwise, it may be a better idea to just install a new door.

Cost is always a factor when considering home repairs and the wise home owner will certainly want to save money by doing some of the work themselves. However, not everyone is a do-it-yourself with enough experience with to accomplish home repairs correctly. When that is the case, remember that by putting off small repairs now you could be setting yourself up for more expensive ones in the future. It is never a good idea to let your home and your security suffer simply because you want to save money.

Installing Carpet Tile

Recently I added a post about using carpet tile in your home. Here is the follow-up on installing it yourself.

Installing carpet tiles is a much easier do-it-yourself job than stretch-in installation, as long as you follow the correct procedure. This type of carpet is installed piece by piece, so finding the starting point is perhaps the most difficult part. Once you get started, this job will go by very quickly and you will have your new carpet ready to use in no time at all.

Find the Center of the Room

Use a chalk-box to snap a line at the midpoint of the opposing walls in the room. You will begin the installation at the center of the room and then work towards the outside. Once you find the midpoint between both sets of walls, the lines will intersect in the center of the room.

Square Your Lines

Before you begin the installation, make sure that the lines are squared. Measure four feet out from the center point on one line and three feet out on the other line. The two marks should be five feet apart for your lines to be squared. If they are not, make the necessary adjustments.

Equal the Edges

Make sure that the tile closest to the wall will be at least half a tile wide. Do this by laying out tiles towards the wall and then stopping when you cannot fit an entire tile between the last tile and the wall. You can then adjust the tiles so that you have room for half a tile on each side. This ensures that both sides are even.

Start Laying Tiles

Begin by laying the center tiles. Put one tile in each quadrant of the center of the room. You will then build out from the square that you have formed. Once the first square has been completed, you can move onto the second and third squares. Continue forming squares until you get close to the wall.

Trim the Tiles to Fit

The tiles that border the walls will have to be trimmed, unless your room is perfectly shaped for these tiles. Measure the area between the last tile and the wall and draw a matching line on the back of the tile. Continue this process until every space has been filled.

Roll Your Floor

Use a 75-pound roller to press the adhesive down and keep the tiles in place permanently.