Installing Carpet Tile

Recently I added a post about using carpet tile in your home. Here is the follow-up on installing it yourself.

Installing carpet tiles is a much easier do-it-yourself job than stretch-in installation, as long as you follow the correct procedure. This type of carpet is installed piece by piece, so finding the starting point is perhaps the most difficult part. Once you get started, this job will go by very quickly and you will have your new carpet ready to use in no time at all.

Find the Center of the Room

Use a chalk-box to snap a line at the midpoint of the opposing walls in the room. You will begin the installation at the center of the room and then work towards the outside. Once you find the midpoint between both sets of walls, the lines will intersect in the center of the room.

Square Your Lines

Before you begin the installation, make sure that the lines are squared. Measure four feet out from the center point on one line and three feet out on the other line. The two marks should be five feet apart for your lines to be squared. If they are not, make the necessary adjustments.

Equal the Edges

Make sure that the tile closest to the wall will be at least half a tile wide. Do this by laying out tiles towards the wall and then stopping when you cannot fit an entire tile between the last tile and the wall. You can then adjust the tiles so that you have room for half a tile on each side. This ensures that both sides are even.

Start Laying Tiles

Begin by laying the center tiles. Put one tile in each quadrant of the center of the room. You will then build out from the square that you have formed. Once the first square has been completed, you can move onto the second and third squares. Continue forming squares until you get close to the wall.

Trim the Tiles to Fit

The tiles that border the walls will have to be trimmed, unless your room is perfectly shaped for these tiles. Measure the area between the last tile and the wall and draw a matching line on the back of the tile. Continue this process until every space has been filled.

Roll Your Floor

Use a 75-pound roller to press the adhesive down and keep the tiles in place permanently.